February 20, 2020: Webinar – Simplifying FDM & PolyJet 3D Printing with Automated Support Removal

If you’re still doing the bulk of FDM or PolyJet support removal by hand or with dated equipment, you’re likely dealing with unnecessarily long wait times, and warped or inconsistently finished parts.

During this 30-minute webinar presented by PostProcess Technologies and AdvancedTek, we’ll introduce you to an automated intelligent solution that will significantly increase the throughput and consistency of your FDM and PolyJet 3D printed parts while reducing operator time and numbers of damaged parts.

Date: February 20, 2020

Time: 11:00 AM – 11:30 AM

Speaker: Francesca Baird, Technical Trainer – PostProcess Technologies

REGISTER BELOW TO SAVE YOUR SPOT!